Foundation And Floor; Installation And Initial Commissioning - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

Table des Matières

Les langues disponibles

8.3 Foundation and floor

Requirements for the concrete floor slab:

9 Installation and initial commissioning

Risk of death and injury from asphalt ground

Only use the lifting system on level, statically tested floor slabs.

Required concrete quality: C20 / 25 with a minimum load-bearing capacity of

Minimum thickness of the bottom plate 115 mm.

Maximum permissible transverse angle to the vehicle: 1% (10 mm / m).

Maximum permissible longitudinal angle to the vehicle: 2% (20 mm / m).

Risk of death and injury due to improper installation

Installation, maintenance and repair work may only be carried out by

trained and authorised specialists whilst the system is switched off and

Work on the electrical equipment of the system may only be carried out by

electricians.

Work on hydraulic equipment may only be carried out by qualified

personnel with special knowledge and experience in hydraulics.

Table des Matières