How to use the Temperature Controller
Lock Function
The "Lock" function will prevent the buttons on the
controller from working a safeguard against small
children or otherwise inappropriate operation.
The "Lock" function can be used whether the
controller is "ON" or "OFF".
When the "Lock" function is active, all other
buttons are locked out except for the "LOCK"
button.
When the controller with priority is locked, all remote
controllers will also be locked. Any controller in this
case can be used to release the "Lock" function. When
all the remote controllers are "OFF", any remote con-
troller can be used to "Lock" all remote controllers.
1.Press "LOCK" button for 3 seconds until "LOCK" icon
appears and controller beeps (unless beep has
been deactivated). Once locked the "LOCK" icon
will be displayed.
2. Press "LOCK" button again for 3 seconds until
"LOCK" icon appears and controller beeps (unless
beep has been deactivated). The controller is now
unlocked and the "LOCK" icon is no longer displayed.
68
NOTE
PRIORITY Icon
CIRCULATION
Icon
Setting Priority
The "PRIORITY" button is only used when there is more
than one temperature controller connected to a tank-
less water heater. Only the controller with the
"PRIORITY" icon will have the ability to change the tem-
perature so as to avoid scalding or other injury (please
"LOCK"
note that if only 1 controller is installed, the "PRIORITY"
Icon
button will remain lit.)
Press "PRIORITY" button
-"Priority" icon will be displayed on the controller
allowing the hot water temperature to be
changed.
*When the controller is being powered "ON" the
controller is prioritized and the "priority" display
is shown.
*When priority is selected, the set temperature of
the prioritized controller becomes the set
temperature of the tankless water heater.
-Regardless of which controller has priority, all
settings or functions other than temperature can
be adjusted and used.
Priority Icon
KBP Series Manual
Hot Water
Temperature
Hot Water
Temperature
Hot Water
Temperature