Setting The Clock Time - Rinnai Rur98I Manuel D'installation Et D'utilisation

How to use the Temperature Controller

Setting the Clock Time

The display will default to "AMPM－－：－－" when
the controller is powered on for the first time.
1. Press the "ON/OFF" button to turn the controller
"OFF"
2. Press the "FUNCTION" button while the controller
is "OFF".

"AM 12:00" will be displayed flashing.
3. Press "UP" or "DOWN" buttons to adjust the
current time.

The "UP" button will move the minute forward,
while the "DOWN" button will move the minute
backward.

Continuous pressing of either button will change
the time by 10 minute intervals.

Pay close attention to correctly set the AM vs
PM especially when the recirculation timer
function is being utilized.
62
4. Press "FUNCTION" button again.

The display will stop flashing and the setting mode
will be exited.

Remember that when the "FUNCTION" button is
pressed while setting the time, the clock starts at 0
seconds allowing the time to be set as accurately
as possible.

Once the time is set, if the "FUNCTION" button is
not pressed to exit the setting mode, the control-
ler will exit the mode automatically after 1 minute.
NOTICE
In the event of a loss of power, the clock will have to
be reset. Failure to do so will cause the timer feature
not to function.
KBP Series Manual