Rinnai RUR98i Manuel D'installation Et D'utilisation page 66

How to use the Temperature Controller
Using the Circulation Function (with Override)
(Refer to "Circulation Function (with Timer) section on previous page for information on setting the timer.)
The "OVERRIDE" function can be used with or without the 'TIMER" operation feature.
Without "TIMER" operation
-"OVERRIDE" function can be used to manually activate circulation by pressing the "OVERRIDE/SELECT"
button on the controller.
- To deactivate the "OVERRIDE" function press the "OVERRIDE/SELECT"
will deactivate automatically after 2 hours.)
With "TIMER" operation
-"OVERRIDE" function can be used to temporarily alternate the programmed circulation ("TIMER") setting.
-Press the "OVERRIDE/SELECTION"
Example: When the "OVERRIDE/SELECTION" button is pressed at 2:30PM, the grids from 2:00PM-5:00PM
will come "ON" and light up.
-The "Override" function is effective only once and will disengage automatically on the next timed setting
sequence. For example in the above case, at 6:00PM, the 2:00PM-5:00PM grids will turn off automatically and
the circulation will now be "OFF".
-The "OVERRIDE" function can be deactivated in the following ways:
1. Press "OVERRIDE/SELECT" during the "Override" function to cancel it and return to the original setting.
2. Deactivating the "TIMER" function.
3. Turning the controller "OFF".
66
button during a "TIMER" operation.
Press "OVERRIDE/SELECT"
KBP Series Manual
again. ("OVERRIDE" function