Operation; Mounting And Fixing Accessories - WOHLHAUPTER 510 digital Série Mode D'emploi

English

3. Operation

For tightening torques, see "6. Spare parts"

3.1 Mounting and fixing accessories

Available accessories include tool holders
, reducing sleeves
9
, and serrated tool body
8
holders . The smaller precision boring
ß
tool (Ø 40 mm / 1.575")
(.315") mounting hole
and the larger tool (Ø 50 mm / 1.969"), a
mounting hole of Ø 14 mm (.551"). If using
a mini-boring tool
8
a smaller shank diameter
sleeve must first be fitted.
7
Fitting the reducing sleeve
Screw back both threaded pins
precision boring tool's slider
they will go. Insert the reducing sleeve
with the smaller outer diameter
mounting hole as far as it will go. Make
"
sure that both cross bores are pointing in
the direction of both threaded pins.
˜
34
fig. 2
12
, mini-boring tools
7
with insert
0
has an Ø 8 mm
1
for the accessory,
"
or tool holder with
9
, a reducing
ˇ
7
in the
"
as far as
„
7
into the
˜
32
1
"
„
Mounting the mini­boring tool
tool holder
When inserting an accessory into the tool's
reducing sleeve
, ensure that the clamping surface
„
pointing in the direction of the threaded
pins . The mini-boring tool
"
or serrated tool body
9
positioned using an adjusting device or
other measuring tool. Bear in mind that
there is a minimum clamping length
"7. Technical data." The threaded pins must
be properly fitted to provide an optimal
cutting edge position and secure hold. For a
proper fit, when tightening the two threa-
ded pins, the shank that is to be clamped
should be turned slightly in the opposite
direction.
Mounting the insert holder
Place the insert holder on the K-section of
the serrated tool body
the fixing screw
has a scale
w
with /
ˇ
without
7
7
" ˜
32
¸
¿
ˇ
or serrated tool body
9
or directly into the slider
7
, tool holder
8
is then axially
0
ß
and clamp it using
0
. The serrated tool body
q
to aid installation.
9
˜
¸
¿
8
¸
¿
ˇ
0
˜
33
w q
,
8
0
is
¿
– see
¸
33
˜
33
ß