Operation - WOHLHAUPTER MVS Mode D'emploi

prescribed by the manufacturer. Any use
which is outside these specifications is
considered improper, and the manufac-
turer is not responsible for damage or
injury resulting from any such use.
Shank types for use in
hydraulic clamping chucks
Form A with smooth straight shank
Straight shank according to DIN 6535 HA
Form AB with flat face and
straight shank with driver surface
Straight shank Form B according to
DIN 1835 Part 1 and DIN 6535 HB
Form B with lateral driver surfaces
Straight shank B according to
DIN 1835 Part 1
Form E with inclined clamping surface
Straight shank E according to DIN 1835
Part 1 A2*) and DIN 6535 HE

3. Operation

Chucking/releasing
The tool shank must be free of swarf and
dirt.
The tool must be introduced into the chuck
to at least minimum chucking depth (see
Technical Data, Page 7).
TIP:
Insert the tool vertically into the hydraulic
clamping chuck.
Screw the clamping screw up to the limit
stop and tighten slightly. Tightening torque
10 – 12 Nm (see Fig. 2).
Approximately 3 – 6 key turns are needed
to release it depending on chuck diameter
Length adjust-
ment screw
Fig. 1
Fig. 2
CAUTION:
The clamping screw is not
secured against falling out!
English
Minimum
chucking depth
Clamping screw
SW 5/ SW 4/ SW 6
Piston
Vent screw
9