Operation - WOHLHAUPTER Alu Line Série Mode D'emploi

English

4. Operation

For torques, see "6. Accessories" and
"7. Spare parts" from page 11.
Clamping the insert holders
5
The slider is provided with a serration,
so that different insert holders
simply and quickly clamped.
Reverse machining
For reverse machining, the insert holder
is turned through 180° and mounted on
the slider.
Note: reverse machining is done with
the spindle running counter-clockwise.
Clamping
To clamp the slider
with a clamping screw
During machining, the slider must be
clamped with this clamping screw. This
clamping arrangement must be operated
before and after each adjustment.
10
2
can be
2
5
6
2 5
6
5
the tool is fitted
6
.
Do not make any diameter
adjustments in the clamped
state! Do not apply any force
during the setting procedu-
re. The adjustment mechanism could
be damaged.
Diameter adjustment
This precision boring tool has an
electronic positioning system with
7
digital display .
Please follow the sequence for setting
the diameter as set out below:
1. Switch on the digital display by ope-
rating the "ON/Reset" button
The last displayed parameter appears
on the display when it is switched on.
Automatic switch-off takes place 30
seconds after the end of the setting
procedure. Max. switch-on duration:
120 seconds.
2. Slacken the clamping screw
3. Adjust the boring range using the
adjusting screw
display. The actually set value for the
diameter at the slide or the cutting
edge is displayed.
Note: no sign = diameter increase,
minus sign (–) = diameter reduction.
4. Tighten the clamping screw for clam-
ping.
Notes:
• When the display is switched on, this
can be reset to "0" by operating the
"ON/Reset" again.
• The difference from the previously set
value or 0 is always displayed. The abso-
lute slide position cannot be displayed.
8
.
6
.
9
while reading the
7
9
8