Geo-Fence; App Settings - Dogtra Pathfinder Guide D'utilisation

Geo-fence

A Geo-fence can be created for an area specified.
The Geo-fence will be displayed on the Map tab. Dog alerts for the Geo-fence
are turned on by default and a notification will appear when dogs exit and
enter the Geo-fence.
· The Geo-fence alerts can be turned on and off in the Settings.
Geo-fence Info
The info button displays more information on setting up the Geo-fence.
Saving a Geo-fence
Long press the map to create a Geo-fence point. Geo-fence points must be
created in clockwise order. Geo-fence points cannot intersect. A valid Geo-
fence is displayed in green. An invalid Geo-fence is displayed in red and
cannot be saved.
Once a valid Geo-fence is created, use the save button to the save the Geo-
fence to the map. Geo-fence points can be edited before saving. Hold and
drag the Geo-fence points to edit its location.
86

App Settings

Screen Saver
· The phone screen turns off when covered or in a pocket and turns on
when viewed.
· On Android devices, the screen will turn off when the proximity sensor is
covered and turns on when the sensor is exposed.
· Turn this feature on and off using the On/Off button.
Shake Control
· Shake your phone to jump between dogs or the main tabs.
· Select between tabs, dogs and no action.
Volume Button Control
· Use the volume buttons to jump between dogs or zoom in/out on the map.
· Select between zoom, dogs and no action.
Distance Unit
· The distance is displayed on the main tabs, and device list.
· Select between meters and yards.
Speed Unit
· Select between seconds and hours.
GPS Data
· The GPS Data Limit sets how far back the tracks are displayed. If 2 minutes
is selected, only the tracks up to 2 minutes will be displayed.
· Select between intervals in 1 to 10 minutes or unlimited.
Tracking Only Mode
The Pathfinder comes equipped with standard 15 mm contact points that
can be extended to 19 mm contact points, for use with dogs with long or
thick coats. Use the included adjustment tool to remove the contact points
and the contact point washers to extend the length of the contact points.
Replace the standard contact points with the non-stimulation contacts to
disable the e-collar hardware. Set the app to Tracking Only Mode while
using the non-stimulation contacts for use where e-collar stimulation is not
allowed. This feature can be used for AKC or UKC events where the GPS is
permissible but the e-collar is not.
· A new history file will begin recording when the Tracking Only Mode is
turned on.
Offline Map Data Usage
Turn Offline Map Data on to use cellular data when available with Offline
maps. Turn Offline Map Data off to restrict data usage and only display
downloaded Offline Maps.
87