Beurer BC 28 Mode D'emploi page 30

• Press the START/STOP button to
start the blood pressure monitor
. All displays will illuminate
briefly.
• The last measured value is dis-
played and the blood pressure
monitor automatically begins the
measurement after 3 seconds.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
displayed.
• Systolic pressure, diastolic pres-
sure and pulse measurements are
displayed.
• _ appears if the measurement has not been per-
formed properly. Observe the chapter on
error messages/troubleshooting in these
instructions for use and repeat the
measurement.
• Now select the desired user memory by pressing the
memory button M. If you do not select a user memory,
the measurement is stored in the most recently used
user memory. The relevant
the display.
• Press the START/STOP button
blood pressure monitor. The measurement is then
stored in the selected user memory.
If you forget to turn off the device, it will switch off auto-
matically after approx. 1 minute.
.
In this case too, the value is stored in the selected or
will be
most recently used user memory.
Wait for at least 1 minute before taking
another measurement.
Evaluating results
Cardiac arrhythmia
This device can identify potential disruptions of the heart
rhythm when measuring and, if necessary, indicates this
after the measurement with the symbol
This can be an indicator for arrhythmia. Arrhythmia is an
illness in which the heart rhythm is abnormal because of
flaws in the bioelectrical system that regulates the heart-
beat. The symptoms (skipped or premature heart beats,
pulse being slow or too fast) can be caused by factors
such as heart disease, age, physical make-up, excess
30
or symbol appears on
to switch off the
.