BFT EOS 120 Instructions D'utilisation Et D'installation page 22

ENGLISH
16) MAINTENANCE
Before carrying out any maintenance operation, disconnect the
system power supply.
• Periodically check the tension of the chain/belt (twice a year).
• Occasionally clean the photocell optical elements, if installed.
• Have a qualified technician (installer) check the correct setting
of the electronic clutch.
• When any operational malfunction if found, and not resolved,
disconnect the system power supply and request the assistance
of a qualified technician (installer). When the product is out of
service, activate the manual release device to allow the door to
be opened and closed manually.
If the power supply cable is damaged, it must be replaced directly
by our company or our technical service department or by a
technician having similar qualification so as to avoid any risks.
16.1) FUSE REPLACEMENT (Fig.25)
WARNING! Disconnect the mains voltage.
Remove the rubber protection from the fuse-carrier. Remove the fuse
(Fig.25, Ref.A) to be replaced and replace it with a new one. After
completing this operation, re-fit the rubber protection.
17) SCRAPPING
Warning! This operation should only be carried out by quali-
fied personnel.
Materials must be disposed of in conformity with the current regula-
tions.
In case of scrapping, the automation devices do not entail any
particular risks or danger. In case of materials to be recycled,
these should be sorted out by type (electrical components, copper,
aluminium, plastic etc.).
18) DISMANTLING
Warning! This operation should only be carried out by qualified
personnel. When the automation system is disassembled to be
reassembled on another site, proceed as follows:
• Disconnect the power supply and the entire external electrical
installation.
• In the case where some of the components cannot be removed
or are damaged, they must be replaced.
The descriptions and illustrations contained in the present
manual are not binding. The Company reserves the right to make
any alterations deemed appropriate for the technical, manu-
facturing and commercial improvement of the product, while
leaving the essential product features unchanged, at any time
and without undertaking to update the present publication.
22 -
EOS 120 VENERE D Ver.01
INSTALLATION MANUAL