Before Operation; Setting The Clock - Sharp R-26ST Mode D'emploi Avec Livre De Recettes

7. R-26ST English 27.01
Plug in the oven.
1. The oven display will flash:
2. Touch the STOP button the display will show:
x1
To set the clock, see below.
There are two setting modes: 12 hour clock and 24 hour clock.
1. To set the 12 hour clock, hold the MICROWAVE POWER LEVEL button
down for 3 seconds.
2. To set the 24 hour clock, press the MICROWAVE POWER LEVEL button once
more after Step 1, in the example below
To set the clock, follow the example below.
Example:
To set the 24 hour clock to 23:35
1. Choose the clock function.
(12 hour clock)
x1 and hold
for 3 secs.
4. Set the minutes. Rotate the
TIMER/WEIGHT knob until
the correct minute is displayed
(35).
NOTE:
1. You can rotate the TIMER/WEIGHT knob
clockwise or counter-clockwise.
2. Press the STOP button if you make a mistake
during programming.
3. If the electrical power supply to your microwave
oven is interrupted, the display will intermittently
3/7/07 3:33 PM Page 5
will appear in the display.
Choose the 24 hour
clock.
x1
5. Press the MICROWAVE POWER
LEVEL button to start the clock.
148/GB-4

BEFORE OPERATION

Using the STOP button
Use the STOP button to:
1. Erase a mistake during programming.
2. Stop the oven temporarily during cooking.
3. Cancel a programme during cooking, touch twice.

SETTING THE CLOCK

will appear in the display.
2. Set the hours. Rotate the
TIMER/WEIGHT knob until
the correct hour is displayed
(23).
Check the display.
x1
show after the power is reinstated. If this
occurs during cooking, the programme will be
erased. The time of day will also be erased.
4. When you want to reset the time of day, follow the
above example again.
x1 and hold
for 3 secs.
3. Press the MICROWAVE
POWER LEVEL button
to change from hours to
minutes.
x1