Table des Matières
Publicité
10
2
13
14
9
15
R
G
T
94
11
12
6.0-1
6.0-2
F
S
6.0-3
Maintenance
Every week,
carry out:
•
Wash with cold water and soap or non-aggressive
chemical detergents.
•
Dust only the
bead breaking disks and tool guards
with talc.
on the parts:
Figure 6.0-1
9) Plastic guards for lifter parts
10) Plastic guards on mount/demount tool
11) Bead breaker disks
12) Plastic guard on wheel holder base.
Perform the following:
•
Clean with a dry cloth
•
Restore a thin film of protective oil
on the following parts:
-) Wheel clamping hub nut
13) Vertical slide cylinder rods on tools
14) Front lifter pneumatic cylinder rods
Figure 6.0-3
•
Check that the lubrication unit is working properly.
One oil drop falling into the transparent cone G every
4-5 complete strokes of the bead breaker indicates
that the correct amount of oil is being dispersed in the
system. If necessary,
•
Adjust the unit using the screw 'R' to correct the oil
flow so it is as indicated above.
Every day,
Perform the following:
•
Clean with a dry cloth
the following parts:
Figure 6.0-1
10) Mount/demount tool plastic guards
11) Bead breaker disks
Perform the following:
•
Clean with a dry cloth and compressed air.
the following parts:
Figure 6.0-2
15) Wheel clamping unit engage housing.
Figure 6.0-3
•
Drain the water from the filter 'F' by pulling the fitting
'S' downwards.
•
Check the level of oil in the lubricator.
Operator's Manual
QUADRIGA 1000/BB
Publicité
Table des Matières
