John Bean QUADRIGA 1000 Manuel De L'opérateur page 106

"Hint 16"
"
Wrong AWP SerNum
"Hint 17"
"
High Vert Stress
"Error"
"Error 101"
"EEPROM not valid"
"Error 102"
"QPower linkdown"
"Error 103"
"QIntface linkdwn"
"Error 201"
"LowerBB Motion"
"Error 202"
"LowBB WrongDir"
"Error 203"
"UpperBB Motion"
106
Trouble shooting
"Hint 16"
"Wrong AWP SerNum"
"
Call the Technical Assistance Service
"Hint 17"
"High Vert Stress"
"
The message appears after the fifth consecutive
interruption. The blocked tool must be rearmed with the
lever. Check the conditions of the tyre and press the
MANUAL MODE key to continue.
A list of the ERRORS shown on the Display:
"Error 101"
"EEPROM not valid"
This error may be displayed only at machine start up if
the software detects an error in the saved data or if the
data is absent; (Call the Technical Assistance Service).
"Error 102"
"QPower linkdown"
There is a communication failure with the Motor Control
Card; (Call the Technical Assistance Service).
"Error 103"
"QIntface linkdwn"
There is a communication failure with the Solenoid Valve
Interface Card; (Call the Technical Assistance Service).
"Error 201"
"LowerBB Motion"
In automatic procedures, this error may be displayed
when the lower bead breaker starts but does not move,
or does not move smoothly; (Call the Technical
Assistance Service).
"Error 202"
"LowBB WrongDir"
This error may be displayed when the lower bead
breaker is activated but moves in the opposite direction
to the required one; (Call the Technical Assistance
Service).
"Error 203"
"UpperBB Motion"
In automatic procedures, this error may be displayed
when the upper bead breaker starts but does not move,
or does not move smoothly; (Call the Technical
Assistance Service).
Operator's Manual
"AWP Laser Sensor Serial Number not valid"
"Excessive bead extraction force"
"The Eprom data is not valid"
"Communication with motor control failed"
"Communication with solenoid valve control failed"
"Lower Bead Breaker Operation"
"Lower Bead Breaker Wrong Direction"
"Upper Bead Breaker Operation"
.
QUADRIGA 1000/BB