Table des Matières
Publicité
2
1
5
6
2
38
3
4
8
7
4.1-1
4.1-2
Layout
4.2 Operating Automated Parts
The Super Automatic Tire Changer operates according
to reset work cycles (Mounting and Demounting
Programs) that can be selected by the operator. Using
these cycles all movements are controlled by the
machine.
The operator is only required to perform a number of
selections and settings on the User Interface keyboard,
after which the various work cycles can begin.
Pressing the Unclamp From Rim pedal
Note:
interrupts the work cycle that is in progress
and deletes the data acquired previously.
At this point, to run another automatic
program you will need to first perform a
data acquisition operation.
The software operates the entire automatic process in
a series of clearly defined steps that are named in the
manual as follows:
Work cycle:
This is the complete tire change procedure, or rather,
the set of Demounting and Mounting Programs.
Program:
This refers to the operations involving Demounting and
Mounting the tire on the rim. The control panel has a
special key for each of the two selections.
Subprogram:
This identifies the subdivision of the programs into the
individual programs performed in both programs.
The figure (Fig.4.2-1) shows the Programs and the
respective Subprograms that make them up.
Phase:
This is a further division of the Subprogram. The
machine stops all movements automatically and emits
a warning "beep". The operator must release the lever
(2, Fig.4.1-2) to confirm the temporary stop request
and then activate lever "2" again to continue the
automatic procedure.
Having loaded the wheel or even just the rim, for the
automated parts to operate correctly you need to:
•
Set the value corresponding to the rim
diameter, using the + and – keys (1 and 2, Fig.4.1-1).
•
Select the required Wheel Mode. By default
the machine always proposes NORMAL, (see the
Selecting Wheel Mode chapter).
•
Select the required program using these keys:
6, Fig.4.1-1 - Automatic Demounting;
(Full Tire Remove) if a complete wheel with
the bead inserted is clamped onto the Wheelholder
Flange.
Operator's Manual
QUADRIGA 1000/BB
Publicité
Table des Matières
