Table des Matières
Publicité
2
5
44
4.1-2
4.1-1
3
4.1-3
Layout
REMOVING THE LOWER BEAD
Keep the lever (2, Fig.4.1-2) activated to operate the
lower tire removal tool.
Then the machine stops automatically as the operator
has to fit the bead onto the tool manually.
Now continue with the last phase where the tire is
removed completely from the rim and the tools and discs
are positioned to start the mounting operations.
The machine emits a beep and the message "MANUAL
MODE" appears again on the display.
At this point the Automatic Demounting Program has
finished.
WARNING:
WHEN THE UNCLAMP RIM PEDAL IS PRESSED ALL
THE ACQUIRED DATA IS DELETED.
4.2.2 Automatic Mounting Program
Having removed the tire, the work cycle can continue
by mounting a new tire.
To proceed with mounting operation you should:
•
Select the Automatic Mounting (5, Fig.4.1-1) key.
Within the Automatic Mounting Program the following
Subprograms are run in this order:
- Mounting the lower bead
- Mounting the upper bead
MOUNTING THE LOWER BEAD
•
Activate the lever (2, Fig.4.1-2).
The tool moves up to the rim. This phase ends with an
initial machine stop.
•
Position the tire on the rim.
•
Activate the Pedal (3, Fig.4.1-3), to fit the lower bead
onto the rim.
Note: Every time the work cycle begins with a Mounting
Program or if the wheel has been unclamped
after the Automatic Demounting Program, the
machine laser scanner scans the entire rim
profile to ascertain the exact positions of the
flanges.
Operator's Manual
QUADRIGA 1000/BB
Publicité
Table des Matières
