John Bean QUADRIGA 1000 Manuel De L'opérateur page 46

2
9
46
4.1-2
3
4.1-3
Layout
MOUNTING THE UPPER BEAD
Activate Lever "2" to position the tools on the upper
side of the wheel.
The automated cycle stops to allow the operator to
create a space manually on the tire to house the tool.
Lever "2" should then be activated again to position the
tool and the disk on the upper bead.
The machine then stops again (the machine beeps) to
allow the valve in the rim and/or the bead pusher aids
to be positioned.
At this point it is essential that you DO NOT USE the
lever "2" to activate rotation. Instead use the pedal (3,
Fig.4.1-3) to mount the upper bead.
WARNING:
DO NOT ACTIVATE THE LEVER BEFORE YOU HAVE
COMPLETED THE BEAD INSERTION OPERATION
USING THE PEDAL.
Having removed the bead pusher aids, activate the lever
"2" again to move the tools and bead breaking disks
into the idle position.
The last phase is now finished; the tools and disks are
out of the operating area, the machine beeps and the
"MANUAL MODE" message appears again on the
Display.
The Automatic Mounting Program is now finished, which
means the entire work cycle is finished too.
Operator's Manual QUADRIGA 1000/BB