John Bean QUADRIGA 1000 Manuel De L'opérateur page 82

5
82
4.1-1
5.2-8
5.2-9
5.2-10
Operations
5.2.2 Mounting
Having completed demounting, only the rim will be left
clamped onto the Wheel Holder Flange.
Proceed as follows:
WARNING:
CHECK THAT THE DIAMETER OF THE TIRE BEING
MOUNTED IS CORRECT.
Lower bead mounting procedure
• Select the Automatic Mounting function key (5, Fig.
4.1-1).
Note: If a tire mounting operation is performed after
a rim clamping operation (new rim or rim
removed after demounting) the first thing the
machine does is to scan the rim flange (Laser
Scan Fig.5.2-8).
• Activate the Lever to position the lower mounting tool
in the start up position.
The machine stops automatically (and beeps) to allow
the rim to be lubricated and the tire to be positioned.
• Activate the rotation command pedal and lubricate
the rim (Fig.5.2-9).
Note: In this situation rotation can be activated using
the pedal command so the operator can
lubricate the rim.
• Place the new tire on the rim, and hook the bead
onto the tool as shown (Fig.5.2-10).
• Using ONLY the rotation command PEDAL finish
inserting the lower bead into the upper part of the
rim.
WARNING:
DO NOT ACTIVATE THE LEVER BEFORE YOU HAVE
COMPLETED THE BEAD INSERTION OPERATION
USING THE PEDAL.
Operator's Manual QUADRIGA 1000/BB