General Control - Sharp MD-E9000H Mode D'emploi

General Control

*07-E10-12-MD9000H(SEEG) 10
Demonstration mode
The first time the unit is plugged in, the unit will enter the demonstration mode. You
will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode), press the DIS-
PLAY (DEMO) button. The unit will enter the low power consumption mode.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the DISPLAY (DEMO) button
again.
To turn the power on
Press the ON/STAND-BY button.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
To change the display brightness (2 levels)
You can switch the display brightness by pressing the DIMMER button on the remote
control.
Dimmed
Opening and closing the CD compartment
The CD compartment cover is motorised.
When the power is turned on, you can open or close the CD compartment by press-
ing the CD 7 (OPEN/CLOSE) button.
Caution:
Do not open or close the CD compartment cover manually. It may cause
malfunctions to the unit.
Be careful not to jam your fingers in the CD compartment cover.
01.4.19, 3:07 PM
MD-E9000H
Brightened
E-10
D
F
S
V
I
N
E