Enhancing Your Stereo System - Sharp MD-E9000H Mode D'emploi

Enhancing Your Stereo System

The connection cable is not included. Purchase a commercially available cable as
shown below.
Red White
E-41
*07-E39-41-MD9000H(SEEG) 41
Listening to the playback sounds from the
connected device
1
. Use a connection cable to connect an external device to the AUX INPUT sockets.
VCR, DVD, etc.
When using video equipment, connect the audio output to this unit and the video
output to a television.
2
. Press the ON/STAND-BY button to turn the power on.
3
. Press the AUX button or the VIDEO/AUX button on the remote control.
4
. Start playback on the external device.
To the
line
5
. Adjust the input level using the TUNING (X or W) button.
output
sockets
6
. Adjust the volume using the VOLUME buttons.
White Red
Recording on a MiniDisc
1
. Use a connection cable to connect an external device to the AUX INPUT sockets.
2
. Press the ON/STAND-BY button to turn the power on.
3
. Press the AUX button.
4
. Load a recordable MiniDisc.
5
. Press the REC button.
6
. Start playback on the external device.
RCA lead 7
. Adjust the recording level using the TUNING (X or W) button.
(not supplied)
8
. Press the A-MARK button on the remote control to activate/deactivate the auto
mark function.
If you turn on the auto mark function, the unit pauses when a silence lasts for
1 second or more, and creates a track number.
9
. Press the MD 06 button.
To stop recording:
Press the MD
Headphones Headphones
Before plugging in or unplugging the headphones, reduce the volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and are between
16 ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
button.
01.4.19, 3:09 PM