Enhancing Your System - Sharp XL-1200C Mode D'emploi

Enhancing Your System

The connection lead is not included. Purchase a commercially avail-
able lead as shown below.
Red
White
E-24
ENGLISH
VCR, DVD, etc.
To the line
output sockets
White
MD recorder
RCA lead
(not supplied)
To the optical
line input socket
Headphones
Connection cable
for digital recording
„ Listening to the playback sounds from
VCR, DVD, etc.
1 Use a connection lead to connect the VCR, DVD, etc. to the VID-
EO/AUX IN sockets.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2 Press the POWER button to turn the power on.
3 Press the FUNCTION button until "AUX" appears on the display.
When operating with the remote control, press the VIDEO/AUX
button.
4 Play the VCR, DVD, etc.
Note:
Red
To prevent hum interference, place this unit away from a television.
„ To record CD signals on MDs
The digital signal from this unit can be recorded by MiniDisc record-
ers, etc.
1 Remove the DIGITAL OUT socket cover.
2 Use a connection cable for digital recording to connect the unit to
the OPTICAL IN socket of a MiniDisc recorder, etc.
3 Press the POWER button to turn the power on.
4 Put the MiniDisc recorder, etc. in the recording mode.
5 Play a CD on this unit.
Note:
Only CD signals can be output.
„ Headphones
z Before plugging in or unplugging the headphones, reduce the vol-
ume.
z Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
z Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME buttons.