Sharp XL-1200C Mode D'emploi page 11

„ Speaker connection
Connect the wire with the white line to the minus (-) terminal and the
black wire to the plus (+) terminal.
Right speaker
White line
Black
Caution:
z Connect the speaker wires to the speakers first, then to the
unit.
z Use speakers with an impedance of 8 ohms or more, as lower
impedance speakers can damage the unit.
z Do not mistake the right and the left channels. The right speaker
is the one on the right side when you face the unit.
z Do not let the bare speaker wires touch each other.
Incorrect
„ Placing the speaker system
There is no distinction between the right and the left speakers.
Left speaker
Speaker grilles are removable:
Make sure nothing comes into contact
with the speaker diaphragms when you
remove the speaker grilles.
Notes:
z The speakers are magnetically shielded.
Therefore, they do not affect the display even you use them near
the TV. However, some colour variation may occur, depending on
the type of TV used.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
z If any kind of magnet or an electromagnet is placed too close to
Incorrect
the TV and the system, irregular colours may appear on the TV
screen.
Left speaker Right speaker
E-9
ENGLISH