Sharp XL-1200C Mode D'emploi page 17

To interrupt playback:
Main unit operation:
Press the button.
To resume playback from the same point, press the
Remote control operation:
Press the button.
To resume playback from the same point, press the
To stop playback:
Press the button.
To remove the CD:
Whilst in the stop mode, press the
Press the CD eject button and remove the CD.
CD Eject Button
Notes:
z After removing the CD, make sure to press the
button and close the CD compartment.
z When the unit enters the stand-by mode, the opened CD com-
partment cover will be closed automatically.
After use:
Press the POWER button to enter the power stand-by mode.
button again.
button.
(OPEN/CLOSE) button.
(OPEN/CLOSE)
Caution:
z Do not stop or move the CD compartment cover manually. It
may cause malfunctions to the unit.
z Be careful not to jam your fingers in the CD compartment
cover.
z If the power fails whilst the compartment is open, wait until the
power is restored.
z If a disc is damaged, dirty, or loaded upside down, "NO DISC" or
"READ ERR" will appear on the display.
z Keep foreign objects out of the CD compartment.
z Subjecting the unit to shock or vibration may cause mistracking.
z When the unit is not being used, be sure to close the CD com-
partment. If it is left open, the lens may be covered with dust and
the unit may not operate properly.
z If TV or radio interference occurs during CD operation, move the
unit away from the TV or radio.
E-15
ENGLISH