Setting The Clock - Sharp MD-E9000H Mode D'emploi

Setting the Clock

This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the CLOCK button and within 10 seconds, press the
MEMORY/ENTER button.
2
Press the 5/3 5/3 or 2/4 2/4 button to select 24-hour or 12-hour
5/3 5/3 5/3 2/4 2/4 2/4
display and then press the MEMORY/ENTER button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
*07-E10-12-MD9000H(SEEG) 12
3
Press the 5/3 5/3 or 2/4 2/4 button to adjust the hour and then
5/3 5/3 5/3 2/4 2/4 2/4
press the MEMORY/ENTER button.
When the 12-hour display is selected, "AM" will change automatically to
"PM".
4
Press the 5/3 5/3 or 2/4 2/4 button to adjust the minutes and
5/3 5/3 5/3 2/4 2/4 2/4
then press the MEMORY/ENTER button.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.)
To check the time when the power is on:
Press the CLOCK button.
The time display will appear for about 10 seconds.
Note:
The "0:00" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock by performing "Setting the Clock" from the beginning.
01.4.19, 3:07 PM
MD-E9000H
D
F
S
V
I
N
E
E-12