Sharp MD-E9000H Mode D'emploi page 125

Using the Radio Data System (RDS) (continued)
To automatically play the desired programme
(EON-PTY)
When the desired type of programme is broadcast, the radio switches to it automati-
cally.
1
Tune in to an RDS station (when a station name is displayed).
2
Press the EON button when "EON" appears.
"PTY TI" will flash for about 4 seconds.
If the EON button is pressed when "EON" is not displayed, "NO EON" will
appear for 4 seconds to indicate that the unit cannot enter the EON stand-
by mode.
3
Whilst they are displayed, select the desired programme type by
pressing the 5/3 5/3 or 2/4 2/4 button.
5/3 5/3 5/3 2/4 2/4 2/4
The selected programme type will flash.
4
Within 4 seconds, press the PTY. TI button.
The selected programme type and "WAITING" will be displayed for 2 sec-
onds each.
"PTY" will appear, and the unit will enter the EON-PTY stand-by mode.
*07-E22-28-MD9000H(SEEG) 26
5
When the specified programme starts on an ON (other network)
station, the unit will automatically switch to the station and "PTY"
will flash.
6
When the programme is over, the unit will automatically return
to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. ("Programme type"
ING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again. ("PTY" will go out.)
01.4.19, 3:08 PM
MD-E9000H
"WAIT-
D
F
S
V
I
N
E
E-26