Table des Matières
Publicité
DK-CL8PH
General control
ENGLISH
ON/STAND-BY
ALARM
RESET
■ To turn the power on
Press the ON/STAND-BY button to turn the power on.
The first time power is supplied to the unit, the clock will be
blinking on the display. Please set the time and date (refer page
8).
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
E-7
■ Display brightness control (DIMMER)
Press the SNOOZE/DIMMER button to adjust the brightness of
LCD display.
■ Volume auto set in
If you turn off and on the unit with the volume set to 17 or higher,
the volume starts at 16.
VOLUME
■ Volume control
Press the Volume button (VOLUME –) to
decrease volume and (VOLUME +) to
increase volume.
■ Auto power off function
The unit will enter the stand-by mode (when iPod or iPhone is
not docked) after 15 minutes of inactivity during:
iPod or iPhone: No connection.
AUDIO IN: No detection of input signal or very low sound
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
(Display is dim)
Dimmer 1
(Display gets dimmer)
Dimmer 2
(Display is bright)
Dimmer off
audibility.
Publicité
Table des Matières
