Demo Mode; Suitability Test Of Cookware - Gaggenau VI 422 611 Notice D'utilisation

Demo Mode

If š" ‹¯ is displayed, demo mode has been activated.
The appliance will not heat up. Disconnect the appliance
from the power supply. Wait 30 seconds before
reconnecting it. Then deactivate the demo mode within
three minutes as follows:
1.
Turn one of the control knobs anti-clockwise to
position Ž.
2.
Turn the same control knob clockwise to position 1.
3.
Turn the same control knob anti-clockwise to position
0.
The illuminated ring around the control knob will be lit
yellow.
4.
Turn the same control knob clockwise to position 1.
The ‹¯ display will be lit and the illuminated ring will
be green.
Wait for five seconds. The ‹"" display will be lit and
the illuminated ring will turn yellow.
Demo mode has now been deactivated.

Suitability test of cookware

This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
1.
Fill the pan with approx. 8 oz. (200 ml) of water, and
place it at room temperature in the middle of the
burner that most closely matches the diameter of the
pan base.
2. Go to the basic settings, and select the ™„ setting.
The ‹"" indicator lights up.
3. Touch the @ or A symbol. The ‹¯ display will be lit. A
signal tone will sound and the burner indicators will
be lit.
The function has now been activated.
The ¥—¯ display will be lit. After a few seconds, the
burner displays will show the results for the quality and
speed of the cooking process.
Check the result using the table below:
Result
‹
The cookware is not suitable for the element and
will therefore not heat up.*
‚
The cookware is taking longer to heat up than
expected and the cooking process is not going as
well as it ought to.*
ƒ
The cookware is heating up correctly and cooking
is progressing well.
* If there is a smaller element available, try the cookware
again on the smaller element.
To activate the function again, touch the @ or A symbol.
Notes
Do not use the wok or wok accessories with this
▯
function.
The flex cooking zone is set to function as a single
▯
burner; only test one item of cookware at a time on it.
If the diameter of the burner that is used is much
▯
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
You can find information about this function in section
▯
~ "Basic settings"
You can find information on the type, size, and
▯
positioning of the cookware in the sections entitled
and ~ "Flexible Cooking Zone".
en-us
FAQ
31