Demo Mode - Gaggenau VG425211CA Notice D'utilisation

The burner goes out while the appli-
ance is in operation.
The illuminated ring behind the control
knob will flash orange and white alter-
nately.
There is a smell of gas in the kitchen.
The appliance paneling becomes
slightly raised at the corners when it is
in operation.
--------
Notes
Each time the mains power is switched on or following
▯
a power failure, a sound is produced when the gas
valves are started up. The illuminated rings around the
control knobs light up green for a few seconds and
then turn yellow. Wait until the illuminated rings
switch off.
When the gas cooktop is switched on, the electronics
▯
open up the gas supply, which produces a short
sound. A sound can also be heard when the setting is
changed. This is normal.
Power failure in the house-
hold:
Following a power failure, the
appliance will remain switched
off for safety reasons.
Gas may be leaking out where
the gas cylinder is connected.
The metal from which the
cooktop is made expands as it
heats up.

Demo Mode

The demo mode is activated if all of the illuminated rings
around the control knobs light up white for 10 seconds
after switching on the appliance. The burner will not
ignite. The illuminated ring around the active control
knob will be lit orange.
You can deactivate the demo mode as follows:
1.
2.
3.
4.
5.
6.
Demo mode has now been deactivated. To save the
setting, always exit the menu as follows:
7.
Turn all control knobs to 0, and then switch
them back on if you wish to continue using the
appliance.
Check that the gas cylinder connection is not
leaking. Open windows and ensure the room
is well ventilated.
This is normal. It will contract again once it
has cooled down.
Turn all of the control knobs to 0. Disconnect the
appliance from the power supply. Wait at least 30
seconds.
Reconnect the appliance. The illuminated rings
around the control knobs light up green for a few
seconds and then turn yellow. Wait until the
illuminated rings switch off.
Then deactivate demo mode within three minutes as
follows:
Turn any of the control knobs anti-clockwise to
position 12.
Turn the control knob clockwise to position 1.
Turn the control knob anti-clockwise to position 0.
Wait until the illuminated ring lights up yellow.
Turn the control knob clockwise to position 1. The
illuminated ring lights up green.
Wait for five seconds. The illuminated ring now turns
yellow.
Turn the control knob to 0. Then turn the control knob
anti-clockwise to position 12. Turn the control knob
clockwise to position 1. Turn the control knob counter-
clockwise to position 0. Wait until the illuminated ring
goes out.
en-us
Faults – What to Do?
19