Siemens SIMOVERT MASTERDRIVES Motion Control Instructions De Service page 254

Parameterization
NOTE
8-22
The drive window contains all elements required for the
parameterization and operation of the connected device. In the lower
bar, the status of the connection with the device is displayed:
Connection and device ok
Connection ok, device in fault state
Connection ok, device in alarm state
Device is parameterized offline
No connection with the device can be established (only offline
parameterization possible).
If no connection with the device can be established because the device
does not physically exist or is not connected, you can perform offline
parameterization. To do so, you have to change to offline mode. In that
way, you can create an individually adapted download file, which you
can load into the device later.
6SE7087-7JK50
Operating Instructions SIMOVERT MASTERDRIVES
09.2006
Siemens AG