Troubleshooting - Arktic 232903 Mode D'emploi

ber (remove unnecessary obstructions).
• Avoid frequent and prolonged opening of the
door.
• Wait a while before opening the door again,

10. TROUBLESHOOTING

A defect of the appliance is often caused by problems which can be easily solved without having
to contact a service technician. In such cases, the following activities should be performed.
10.1. IF THE APPLIANCE DOES NOT WORK, CHECK WHETHER:
• The plug is firmly secured in the power outlet
• The power cord is not damaged.
10.2. IF THE REQUESTED TEMPERATURE IS NOT OBTAINED, CHECK WHETHER:
• The controller switch is on,
• The settings on the electronic control panel
are correct (see item 8.3),
• The appliance is undergoing a defrosting cy-
cle or whether the defrosting cycle just end-
ed,
• The condenser is covered with dust,
• The appliance is located close to a source of
10.3. IF THE APPLIANCE GENERATES EXCESSIVE NOISE, CHECK WHETHER:
• There are no loose screws in the frame,
• The appliance is placed on a stable surface
and is properly levelled.
In case the appliance still makes excessive
noise after performing the above activities,
please contact technical service. Be ready to
10.4. HIGHLY IMPROBABLE RISK
• In case of fire, disconnect the appliance from the mains if possible and use a powder extin-
if it has just been closed (suction force cre-
ated in the chamber after the door is closed
will hinder its subsequent opening, which is
a standard phenomenon).
heat or the airflow around the condensation
unit is not obstructed,
• The products stored or other objects make it
impossible to close the door properly,
• The appliance is operating in abnormal
working conditions (excessive load, too many
products inside, products are placed in a
manner which obstructs air circulation).
provide the following information:
• The trade name of the model as well as the
serial number (this can be found on the rat-
ing plate),
• Error codes appearing on the display of the
control panel.
EN
13