EUROM WALL DESIGNHEAT 2000 WIFI Manuel D'utilisation page 19

 By pressing the mode button III (2), you can consecutively set: ventilation - heating at
half power - heating at full power - heating at full power with oscillation - off. The
corresponding lamps will light up.
 With the temperature- and wifi button (3) you can set the temperature: each time
pressing is one degree higher, up to 49°C. After that pressing again will switch back to
10°C.
 The appliance cools down for 30 seconds with emergency operation too.
Wi-Fi and app operation
The heater can also be controlled with an app on your smartphone. To do this, the heater
must be connected to a Wi-Fi modem. To install the app, refer to the end of this booklet.
Timer
The Wall Designheat 2000 Wifi has a timer function that can be used with the app on your
smartphone
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough fresh air.
As mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or ceiling or
something similar. When the heater has cooled down sufficiently, it will in principle start
again automatically, however if you do not remove the cause of the cut-off then this will
probably be repeated. Regular overheating can give rise to irreparable damage.
If the overheating protection switches the heater off, then you must set the main switch to
OFF (O), unplug and allow the heater to cool down. Remove and/or amend the cause of
overheating and reuse the heater as normal. If you cannot find a cause and overheating
recurs, stop using the heater, and take it in for inspection/repair.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions!

Using a vacuum cleaner, carefully remove any dust and dirt from the grills and ensure
that the air intake and outlet openings are clean. Be careful not to touch or damage
any internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if possible.
Store upright in a cool, dry and dust-free place.

Do not dispose of heater with household waste when if becomes worn or damaged
beyond repair. Take it to your local authority's collection point for electrical appliances
where any reusable materials will be collected and redistributed.
Never touch a working appliance!
19