EUROM WALL DESIGNHEAT 2000 WIFI Manuel D'utilisation page 17

28. The appliance (incl. cord and plug) may only be opened and/or repaired by properly
authorised and qualified persons.
29. Only use this heater for its intended purpose and as described in this instruction
manual.
Not abiding by instructions 27, 28 & 29 may lead to damage, fire and/or personal injuries.
A failure to adhere to these rules also immediately nullifies the guarantee and vendor,
importer and/or manufacturer do not take responsibility for any of the consequences!
Description
The remote control works on a cell battery, type CR2025 (3V)
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.

Select a suitable place for the device, taking into account the safety instructions. The
WALL DESIGNHEAT 2000 WIFI has to be hung from a wall and therefore may not be
used in a lying, leaning, hanging or standing position! The wall on which the device is
hung has to be firm, flat and perfectly vertical and made from non-inflammable
1. Main switch
2. Mode button (III)
3. Temperature & wifi
4. Suction grilles
5. Air discharge grille
6. Display
Remote control:
7. ON/OFF button
8. Mode switch (MODE)
9. Swing=oscillate
10. Increase temperature
11. Decrease temperature
Display:
A. Ventilation lamp
B. Heating lamp (half
C. Heating lamp (full
D. "Oscillation" lamp
E. "Timer set" lamp
F. Wifi signal found
17
(top side)
power)
power)