Extensions; Wet And Dry Applications; Maintenance And Repairs - Nilfisk T75 Manuel D'instructions

Masquer les pouces Voir aussi pour T75:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables:
Maximum length = 20 m
Cable = H07 RN - F
Max power (kW)
Minimum section (mm
)
2
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the data
plate.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 ms or an equivalent protection circuit.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
07/2018

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
15
materials for which the vacuum cleaner is used.
10
If the version for liquids is used:
■ Make sure the liquid level sensor is working
correctly before vacuuming liquids.
■ If foam forms, turn off the vacuum cleaner
immediately and empty the container.
■ Warning: Switch off the vacuum cleaner
immediately if foam or liquid leaks out.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
■ Warning: Dirty liquid vacuumed up by the vacuum
cleaner must be considered conductive.
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.

Maintenance and repairs

Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to obtain another version/variant, the
plug must be removed from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the EC declaration of conformity
issued with the device.
5
[ NOTE ]
WARNING!
WARNING!
WARNING!
WARNING!
T75
GB
C360

Publicité

Table des Matières
loading

Table des Matières