Primary Filter Replacement; Hepa Filter Replacement - Nilfisk T75 Manuel D'instructions

Primary filter replacement

Figure 12
1. Vacuum hose
2. Band
3. Cover
Before proceeding with these operations, turn off the vacuum
cleaner and remove the plug from the power socket.
■ Remove the vacuum hose (1).
■ Use the band (2) to remove the cover (3) together with
the filter.
■ Remove the old filter from the cage.
■ Fit the new filter and secure it in the cage with special
clamps.
■ Install the cover and the filter in the reverse order of
removal.
■ Dispose of the old filter according to the laws in force.
07/2018

HEPA filter replacement

WARNING!
Take care not to raise dust when this operation is
carried out. Wear a P3 mask and other protective
clothing plus protective gloves (DPI) suited to the
hazardous nature of the dust collected, refer to the
laws in force.
WARNING!
Do not use the absolute filter again after having
removed it from the vacuum cleaner.
1. Vacuum cap
2. Locking lever
3. Safety bolt
4.
Absolute filter lock ring
5. Absolute filter disc
6. Absolute filter
WARNING!
Reassemble with care to avoid trapping your hands
between the vacuum unit and the container. Use
gloves that provide protection against mechanical
risks (EN 388) with a level of protection CAT. II.
Before proceeding with these operations, turn the vacuum
cleaner off and disconnect the plug from the power socket.
■ Unlock the safety bolt (3).
■ Use the lever (2) to release the cap (1) then pull it up and
out of the vacuum cleaner.
■ Unscrew ring (4).
■ Pull out disc (5) and absolute filter (6).
■ Place absolute filter (6) in a plastic bag, close the bag
hermetically and dispose of the filter in accordance with
the laws in force.
■ Insert a new filter (6) with the same filtering
characteristics as the removed one.
■ Lock the absolute filter with disc (5) and tighten ring (4).
■ Insert the cap (1) again.
■ Fix the cap in place with the lever (2) and lock the safety
bolt (3) again.
9
Figure 13
T75
GB
C360