Extensions; Wet And Dry Applications; Maintenance And Repairs - Nilfisk ATTIX 145-01 Manuel D'instructions

WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
■ Only replace the electric power cable with one of
the same type as the original: H07 RN - F. The same
rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables:
Maximum length = 20 m
Cable = H07 RN - F
Max power (kW)
Minimum section (mm )
2
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the data
plate.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 ms or an equivalent protection circuit.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
03/2011

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
If the version for liquids is used:
■ Make sure the liquid level sensor is working
■ If foam forms, turn off the vacuum cleaner
■ Warning: Switch off the vacuum cleaner
■ Regularly clean the liquid level limiting device
■ Warning: Dirty liquid vacuumed up by the vacuum
3 5
2.5 4
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.

Maintenance and repairs

Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to obtain another version/variant, the
plug must be removed from the socket.
■ Carry out only the maintenance operations
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the EC declaration of conformity
issued with the vacuum cleaner.
5
ATTIX 145-01 / ATTIX 155-01
[ NOTE ]
WARNING!
WARNING!
correctly before vacuuming liquids.
immediately and empty the container.
immediately if foam or liquid leaks out.
and check to make sure that there are no signs of
damage.
cleaner must be considered conductive.
WARNING!
WARNING!
described in this manual.
GB
C366