Controls, Indicators And Connections; Inspections Prior To Starting; Starting Up; Starting/Stopping The Vacuum Cleaner - Nilfisk ATTIX 145-01 Manuel D'instructions

Controls, indicators and connections

Figure 4
1. Dust container release lever
2.
Castor lever
3. Manual filter shaker knob
4. Start/stop switch (normal version)
5. Start/stop switch (version for vacuuming liquids)

Inspections prior to starting

Figure 5
1. Inlet
Prior to starting, check that:
■ The filter is installed.
■ All latches are tightly locked;
■ The vacuum hose and tools have been correctly fitted
into the inlet (1);
■ The bag or safety container is installed, if applicable.
Do not use the vacuum cleaner if the filter is faulty.

Starting up

Figure 6
1. Castor brakes
2. Start switch (normal version)
3. Start switch (version for vacuuming liquids)
Lock the castor brakes before starting the vacuum cleaner (1).

Starting/stopping the vacuum cleaner

Normal version
■ Turn the switch (2) to "I" position to start the vacuum
cleaner.
■ Turn the switch to "0" position to turn the vacuum cleaner
off.
Version for vacuuming liquids
■ Turn the switch (3) to "I" position to start the vacuum
cleaner.
■ Turn the switch to "0" position to turn the vacuum cleaner
off.
Checking the rotation direction of the vacuum unit
motor
Check the vacuum cleaner operation by putting a hand on the
inlet.
If the vacuum cleaner expels the air from the vacuum hose,
the rotation direction is not correct; remove the plug from the
socket and turn the selector inside the plug to perform the
correct phase connection.
03/2011

Shaking the primary filter (Fig. 7)

Depending on the vacuumed dust quantity and if the pointer
of the vacuum gauge switches from the green zone (2) to the
red zone (3) turn the vacuum cleaner off and shake the main
filter with the knob (1).
WARNING!
Stop the vacuum cleaner before shaking the filter.
Do not shake the filter while the vacuum cleaner is on,
as this could damage the filter itself.
Wait before restarting the vacuum cleaner, to allow the dust to
settle. Replace the filter element if the pointer still remains in
the red zone (3) even after the filter has been shaken (consult
the "Primary filter replacement" paragraph).

Emergency stopping

Turn the main switch to "0" position.

Emptying the container

WARNING!
Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.
Before emptying the container it is advisable to clean the filter
(see "Shaking the filter" paragraph).
1. Dust/liquid container
Normal version
■ Release the container (1), then remove and empty it.
■ Make sure the seal is in perfect condition and correctly
positioned.
■ Place the container back in position and secure it again.
Version for vacuuming liquids
■ When the liquid container is full, the vacuum cleaner
automatically stops.
To start the vacuum cleaner again:
■ Disengage the container (1), remove it and drain the
liquid with the relevant valve.
■ Clean the grill inside the container to remove debris or
solid residues which may prevent the liquid from draining
properly.
■ Make sure the seal is in perfect condition and correctly
positioned.
■ Place the container back in position and secure it again.
7
ATTIX 145-01 / ATTIX 155-01
Figure 8
GB
C366