Compensating For The Input Signals - Sony UP-2300P Mode D'emploi

This section explains the following settings and adjustments.
• Compensating for the input signals (on this page)
• Matching the video monitor color to the printout color (page 72)
• Adjusting the printout color and sharpness (page 75)
• Adjusting the tone of the printout (page 80)
• Changing the printout size/printout area (page 82)
• Selecting the operating mode for automatic printing capability (page 85)
• Erasing the screen display (page 89)
• Adjusting the printer window display brightness (page 91)
• Selecting whether to enable the operation and error tones (page 93)
• Setting the baud rate for computer communication (page 95)

Compensating for the Input Signals

A video image recorded under poor conditions may be of poor color quality. If the
signal is an NTSC or PAL composite video signal or separate luminance (Y) and
chrominance (C) signals, you can correct the color and level of the input signal to a
certain extent on the INPUT SETUP menu.
Note
You cannot adjust an image once it has been stored in memory. Restore an image
after adjustment.
1
2, 4
3
When the memory image is displayed on the screen, press the SOURCE/
MEMORY button.
The image from the video source appears.
1
Continue to next page m
Installation and Adjustment
69