Making Printouts For Stickers - Sony UP-2300P Mode D'emploi

Making Variations of Printouts (continued)

Making Printouts for Stickers

42
Operation
The unit supports application modes such as STICK DUP or STICK DIF that
allows you to make a printout for a sticker.
• STICK DUP application mode allows you to make a printout with four or 16
identical reduced images.
• STICK DIF application mode allows you to make a printout with four or 16
different reduced images.
For details of how to select the STICK DUP or STICK DIF application mode, see
"Selecting the Printer Application Mode" on page 25.
Also, you have to use the following ink ribbon cartridge and paper for stickers
• UPC-20S16E print pack for sticker with 16 reduced images
• UPC-20S04E print pack for sticker with four reduced images
For detailed information on the print pack, see "Ink Ribbon Cartridge and Paper"
on page 99.
Before making a printout for a sticker
• Select either the STICK DUP or STICK DIF application mode (see page 25)
• Select the type of the multiple reduced images, that is 4 or 16 (see page 32).
The procedure for selecting the number of reduced images is the same as that in
standard application mode.
However, in the LAYOUT SETUP menu it is different. You cannot select the
MEMORY mode, and SEPARATE is automatically set and fixed to the one with
white borders.
• Select the appropriate memory page. (see page 31)
About the memory mode
You are not allowed to select the memory mode. The memory mode is
automatically set to either frame or field.
To make a printout for a sticker, proceed as follows.
1
Start the video source.
This operation is done using the controls of the video equipment acting as the
source.
3
2 4