Connections; Making Connections For Storing Video Images - Sony UP-2300P Mode D'emploi

Connections

To enable printing, video equipment to act as an input signal source, and a video
monitor to display images or menus must be connected.
The following diagrams illustrate how to make the input, output and remote control
connections. Use this as a guide when connecting the necessary signals to and
from the equipment to be used for printing.
Notes
• Turn off the power of each device before attempting to make any connections.
• Connect the AC power cord last.

Making Connections for Storing Video Images

Connect the video equipment providing the video images to be printed.
Connect the video equipment which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see "Important safeguards/notices for use
in the medical environment" on page 2.
For only UP-2330P
Electronic flash
to STOROBE ( × terminal)
REMOTE
RS-232C
1 2
STROBE
UP-2330P
a) The RGB/SYNC INPUT connectors are equipped with models other than
UP-2300P/2330P.
b) This selector is equipped with UP-2900MD/2950MD only. Set the NTSC/
PAL selector to your TV system. To switch the TV system, turn the power
off once, then change the setting. If you change the setting with the power
on, this mode will not be switched.
to RGB output
connectors
75-ohm coaxial
cable with BNC
connectors
a)
to RGB/SYNC INPUT
R
REMOTE
RS-232C
1 2
R
Video equipment
to S-
to composite video output
VIDEO
connector
output
conne
-ctor
Connecting cable
(with DIN 4-pin
75-ohm coaxial
connectors) YC-
cable with BNC
15EV connectors
to S-VIDEO
to VIDEO INPUT
INPUT
UP-2900MD/2950MD
INPUT
G B SYNC S-VIDEO VIDEO
NTSC
OUTPUT
PAL
G B SYNC S-VIDEO VIDEO
NTSC
NTSC/PAL
b)
selector
PAL
Installation and Adjustment
~
AC IN
to AC IN
to wall outlet
65