Connections; Parallel Cable Connection - Sony UP-D6500 Mode D'emploi

Connections

The following examples show the connection of the
system to print cards. The UP-D6500/D6400 and
D6300 are equipped with a parallel connector for
connecting to the computer with a parallel cable. The

Parallel Cable Connection

Notes
• Turn off the power to all devices when making connections.
• Connect the power cords last.
• Insert the parallel data cable connector firmly, as far as it will go.
• The parallel cable should be no longer than 3 meters, and conform to the Centronics specification. However, the
type of connectors on the parallel cable depends on the computer and other peripheral devices being connected.
Refer to the operating manuals for the devices for details.
• To use the high speed drive mode (ECP mode), the cable should comply with IEEE1284, such as the Hewlett
Packard model C2950A.
• Do not use the SCSI interface when using the parallel interface.
Personal Computer
To parallel
connector
1) Use a parallel cable that complies with IEEE-1284. Refer also to the computer operating manual for the type of parallel
cable to use.
* The UP-D6300 and D6400 do not have SCSI connectors or a SCSI ID switch.
D6500 is also equipped with a SCSI connector, which
can be used with a SCSI cable instead of the parallel
connection.
Clip bail locks on both sides
Parallel cable 1)
UP-D6300/D6400/D6500
To AC IN
To parallel
To power outlet
connector
17
Preparation