Installing The Cleaning Rollers - Sony UP-D6500 Mode D'emploi

Installing the Cleaning Rollers

This procedure describes how to install the cleaning
rollers in the printer.
1
Hold both sides of the front door, and pull it down
to open.
2
Pull on the cleaning roller cover marked PULL
OPEN to remove the cover.
3
Install two cleaning rollers into the cleaning roller
holder.
Be careful to avoid touching the roller surfaces, as
printing could be degraded.
Insert the roller axles into the slots.
When installing cleaning rollers in the printer the
first time, skip this step and proceed to step 4.
4
Insert the cleaning roller holder into the printer,
and push it until it stops.
Guide
Align the top and bottom guides with the rails
when inserting.
5
Install the cleaning roller cover removed in step 2.
6
Close the front door.
Note
After using the cleaning rollers for a long time, their
cleaning ability will be degraded, causing colors to fail
to transfer properly to the printout. To avoid this, wash
the cleaning rollers each time after printing about 200
cards (page 27).
Rail
Insert the bottom edge of the
cover first, then push the top
edge.
13
Preparation