In Case Of Problems; About Caution Indicator Lamps - Sony UP-D6500 Mode D'emploi

In Case of Problems

If you encounter a problem while using the printer, please check whether the following information can help you
fix the problem before contacting the Sony Service Center.

About Caution Indicator Lamps

Indicator lamps light or blink when an error occurs, to indicate the cause of the error. The table below shows the
various lamp error conditions and their corresponding remedies.
Lamp State ( =lit, =blinking,
ALARM RIBBON CARD
1) Turning the printer off and back on should automatically remove a jammed card.
26
Appendixes
Appendixes
=off)
PRINT READY
The ink ribbon is getting short.
→ Prepare a new ribbon.
End of ribbon.
→ Replace the ribbon (page 11).
The Auto Card Feeder is empty.
→ Add cards (page 23).
The internal Bad Card Stacker is full.
→ Remove the bad cards.
A card is jammed in the manual feeder.
→ Turn the power off and back on.
A card is jammed in the printing mechanism.
→ Turn the power off and back on.
A card is jammed in the card inverting mechanism.
→ Turn the power off and back on.
A card is jammed in the bad card ejecting mechanism.
→ Turn the power off and back on.
A card is jammed in the first Auto Card Feeder.
→ Turn the power off and back on.
A card is jammed in the second Auto Card Feeder.
→ Turn the power off and back on.
A card is jammed in the Auto Card Stacker.
→ Turn the power off and back on.
The print head is dead.
→ Replace the print head.
An error occurred that requires technical service.
→ Contact the nearest Sony Service Center.
Description/Remedy
1)
1)
1)
1)
1)
1)
1)