Installing The Auto Card Stacker - Sony UP-D6500 Mode D'emploi

Using Optional Accessories

Installing the Auto Card Stacker

1
Push down on the upper knob and remove the
connector cover.
Remove the upper edge first,
then the lower edge
2
Align and insert the connector and guide pins on
the Auto Card Stacker to the connector and guide
holes on the printer.
Align the connectors
3
Push the Auto Card Stacker so the connectors mate
firmly.
Push firmly
16
Preparation
Align the guide holes
Also Installing the Supplied Card Tray
Install the supplied card tray after installing the Auto
Card Stacker. The card tray installs on the outside of
the Auto Card Stacker, using the same procedure as for
installing it on the printer (page 14).
Removing the Stacker
To remove the stacker, open the stacker cover and
push down on the locking level while separating the
stacker from the printer.