Remotely Controlling The Printer - Sony UP-980 Mode D'emploi

If the printout image is blurred
A rapidly moving image may be blurred when printed. Should this occur, change
MEMORY to FIELD on the MEMORY sub menu of the PICTURE main menu.
(See page 77.)
If the brightness and/or contrast of printouts is unsatisfied
You can adjust the brightness and contrast of printouts using the BRIGHTNESS
sub menu and the CONTRAST sub menu.
Pressing the BRIGHT button on the sub panel results in accessing the
BRIGHTNESS sub menu easily. (See page 78.)
Pressing the CONTRAST button on the sub panel results in accessing the
CONTRAST sub menu easily. (See page 78.)

Remotely controlling the printer

You can remotely control the printer using the RM-91 remote control unit or the
FS-20 foot switch.
Since the button on the remote control unit or foot switch functions exactly same as
the PRINT button, pressing either of them results in an image being captured and
immediately printed in single picture mode.
If INTERRUPT is set to ON on the INTERRUPT sub menu of the PRINTER main
menu (see page 84), pressing the switch on the remote control unit or foot switch
during printing causes the printer to stop, capture the image now displayed and
start printing of new image.
63
Operation