Precautions - Sony UP-980 Mode D'emploi

Others

Precautions

On the safety
On operation
On printer carriage
On installation
94
Others
• Check the operating voltage before operation.
Operate the unit only with a power source specified in the "Specifications".
• Stop operation immediately if any liquid or solid objects fall into the cabinet.
Unplug the unit and have it checked by qualified personnel.
• Unplug the unit from a wall outlet if you will not be using it for a long time.
Disconnect the power cord by grasping the plug. Never pull the cord itself.
• Do not disassemble the cabinet. Refer servicing to qualified personnel only.
• Keep fingers clear of the door panel when the the door panel is closing.
• Connect the power plug of the printer to a wall outlet that is safely grounded.
Do not turn the power off while the printer is printing. The thermal head may be
damaged.
Do not carry or move the printer when a paper roll is being placed in the printer;
Doing so may cause a malfunction.
• Place the printer on a level and stable surface during operation.
• Do not install the printer near heat sources. Avoid locations near radiators or air
ducts. Also, do not place subject to direct sunlight or excessive dust, humidity,
mechanical shock or vibration.
• Provide adequate air circulation to prevent heat buildup. Do not place the printer
on surfaces such as rugs, blankets, etc., or near materials such as curtains and
draperies.
• If the printer is subjected to wide and sudden changes in temperature, such as
when it is moved from a cold room to a warm room or when it is left in a room
with a heater that tends to produce large amounts of moisture, condensation may
form inside the printer. In such cases the printer will probably not work properly,
and may even develop a fault if you persist in using it. If moisture condensation
forms, turn off the power and allow the printer to stand for at least one hour.