Printing From A Computer; Installing The Printer Driver; Connection To A Computer - Sony PLS PIX1L Mode D'emploi

Printing From a Computer

When a commercially available USB cable is used to
connect the unit to a computer, data sent from the
computer can be printed out using this unit.
When the USB cable is plugged in, the indication "PC
MODE" is shown on the display of the unit. In this
condition, the touch panel is inactive.
To print from a computer, you need to access the [System]
tab on the administration screen and set [PC Connection]
to [ON].

Installing the Printer Driver

If the unit is to be controlled from a computer, you must
install the supplied printer driver on the computer before
connecting the unit to the computer for the first time. For
details on installation, refer to the installation guide and the
Readme file on the supplied CD-ROM.
Note
The supplied printer driver does not support printing via a
network.

Connection to a Computer

To control the unit from a computer, you must connect the
unit to the computer using a commercially available USB
cable. Plug the USB cable into the USB port (device) on
the rear of the unit.
When making the connection, you should also consult the
documentation of the computer.
USB cable
Note
If the connection is made via a USB hub, correct operation
is not assured.
Attaching a ferrite core to a USB cable
Before connecting a USB cable (not supplied) to the
printer, you should attach a supplied ferrite core to its cable
for noise prevention. To conform to radiation standards,
attach the supplied ferrite core to the USB cable of your
device as described below.
1
Release two stoppers on the ferrite core to open it.
2
Slip the USB cable through the ferrite core and
position it at the base of the USB connector to the
printer.
3
Close the ferrite core until you hear a click.
Note
When the ferrite core cannot be secure because the USB
cable is thin, secure it using a tape.
Computer
51
Printing From a Computer