Sony PLS PIX1L Mode D'emploi page 119

8
The adhesive surface of the cleaning sheet is exposed
now, so check again to make sure that none of the
corners have peeled up and the center has not been
raised.
9
Touch the OK button in the confirmation message.
Cleaning begins. The print paper is drawn into and
then reemerges from the eject slot, which removes any
foreign particles and grime inside the printer.
When cleaning finishes, the print paper is cut several
times.
Note
After cleaning is finished, make sure the cleaning
sheet is completely ejected. If any part of the cleaning
sheet remains on the print paper, remove the paper
holder and cut off all the remainders before using the
printer.
10
Remove the cleaning cartridge, and reinsert the ribbon
cartridge.
Notes
• Print paper is needed to perform cleaning. If there is
insufficient print paper remaining, an error message may
appear. Replace the print paper and try performing
cleaning again.
• The print paper used during cleaning is trimmed off
automatically.
When the cabinet becomes dirty
If the cabinet is extremely dirty, soak a clean cloth in
water, or a solution of water and a neutral detergent, wring
out the cloth, and then wipe the surface of the cabinet.
Next, wipe clean with a clean, dry cloth.
To avoid damaging the surfaces of the unit, never use
thinner, benzene, alcohol, or any other type of organic
solvent to clean the unit.
When the display becomes dirty
When the display has become considerably dirty, wipe it
clean with a dry cloth or with a clean cloth soaked in water
and thoroughly wrung out. Do not use even a mild
detergent, as it can damage the surface of the display.
Never touch or strike the surface of the display with a hard
object.
When the filter for the cooling fan
becomes dirty
When the filter for the thermal head cooling fan has
become considerably dirty, remove it and rinse off the dirt
with water. Do not scrub the filter mesh with a brush or
other cleaning tool.
57
Cleaning