Sony PLS PIX1L Mode D'emploi page 74

When using 5-inch wide print packs
Remove the adaptors from the paper holder.
Note
Store the adaptors in a safe place so as not to lose them.
Loading the paper roll and ribbon
cartridge
When using the printer for the first time, you must first
load a paper roll and ribbon cartridge. When using the
2PIX46, adaptors must be installed in the paper holder, as
described in the section "Attaching adaptors to paper
holder" on page 11.
For information on how to remove a spent paper roll and
ribbon cartridge, see the section "Removing the paper roll
and ribbon cartridge" on page 15.
Notes
• Always use a designated print pack.
• Always replace the paper roll and ribbon cartridge
together as a set.
Loading the paper roll
1
Insert the paper core into the paper roll.
12
Installation
Notes
• If the edges of the paper roll are uneven, make sure
to even them out before installing the paper roll.
Otherwise a malfunction may occur.
• If the paper is wound loosely around the core, make
sure to wind it tightly before installing the paper roll.
Otherwise a malfunction may occur.
• Do not grasp the paper too tightly or strike it against
a hard object, because the paper may tear or crease,
effecting the print quality.
2
Open the front door.
3
Press the paper holder release button and pull the paper
holder out.