Operation; Printing; Making Printouts - Sony UP-895 Mode D'emploi

Printing

Before making printouts
Confirm the following:
• Are the connections correct? (page 22)
• Are the slide switches and DIP switches set correctly?
(pages 22 and 23)
• Is the paper type set correctly? (page 23)
• Is the paper roll loaded properly? (page 26)
• Is the video source being input?

Making Printouts

1
Press the power switch to turn on the printer.
The power lamp lights and the EMPTY lamp blinks
for a few seconds.
Power lamp
Note
Make sure that the EMPTY lamp turns out after
blinking for a few seconds. If lit, the paper has run
out. Load the paper. ("Loading Paper" on page 26)
2
Select the printing direction and image size.
See "Selecting the Printing Direction/Image Size" on
the next page.
3
Start the video source.
This operation is done using the controls of the video
equipment which you are using as a source.
4
When the image you want to print is on the video
monitor, press the PRINT button.
The image displayed at the instant you press the
PRINT button is captured into memory and is
printed out immediately.
To interrupt printing
Press either the OPEN or FEED button while printing.
The printer stops printing.
EMPTY lamp
To stop printing and print another image
displayed on the video monitor
To do this, DIP Switch 1 (INTERRUPT) must be set to
ON (SW-DOWN). (See page 24.)
Press the PRINT button while printing or copying. The
printer stops printing, captures the new image, and starts
printing the new image.
In SMALL mode, the printer stops printing and captures
the first image.
If the printout image is blurred
A rapidly moving image may be blurred when printed.
Should this occur, change DIP Switch 4 (MEMORY)
to FIELD (SW-UP). (See page 24.) The printout quality
will be poorer, but less blurred.
To print in SMALL mode
You can print in SMALL mode, where two different
images can be captured and printed together on one
printout, by setting the image size selector on the front
panel to the SML position.
To print in SMALL mode: Press the PRINT button
twice in step 4. When you press the PRINT button once,
the buzzer sounds and the first image is captured. The
printer starts printing after the PRINT button is pressed
twice.
For detailed information on SMALL mode, see
"Selecting Printing Direction/Image Size" on the next
page.
To feed the paper
Press and hold down the FEED button to feed the paper.
Do not pull out the paper manually.
Storing printouts
• Avoid storing printouts in a location subject to the
following. Storage of your printouts in such a place
results in fading of printouts.
– Store printouts in a cool and dark place (below
30°C or 86°F). We recommend storing printouts in
a bag made of clay-free paper or polypropylene.
– Do not store printouts in a hot or humid place. Do
not leave printouts in direct sunlight or other bright
places.
– Do not allow any volatile organic solvent or vinyl
chloride to touch printouts. Alcohol, plastic tape or
film will cause the printout to fade.
• Do not stack your printouts on or under a diazo copy
sheet. Also do not attach the printed surface to another
printed surface. The printout may become discolored.
• To attach the printout to another piece of paper, use
double-sided adhesive tape or water-based glue.
Printing
27

Operation