Setting The Dip Switches On The Rear Panel - Sony UP-895 Mode D'emploi

B GAMMA switch
Sets the tone of printouts (density gradation).
I: Soft gradation
II: Standard
III: Hard gradation
The diagram below shows the curve of density
graduation for each tone.
High
I
II
Low
0 Gradation
Note
This switch is effective only when you use paper types
UPP-110HD or UPP-110HG, that is, when the PAPER
TYPE switch C is set to either II or V.
C PAPER TYPE switch
Selects the paper type.
Set the switch to the type of paper to be used.
Type of paper Switch position
UPP-110S I (Normal)
UPP-110HD II (High density)
UPP-110HG V (High glossy)
D SMOOTHING switch
Selects the line density.
OFF: Normally keep this switch to this position.
ON: To set the print line density to high density and
obtain the better print quality, set the switch to this
position. However, the printing speed is slower than at
the OFF position.
Note
This switch becomes effective under the following
conditions.
• When the STD/SIDE selector on the front panel is set
to STD, and ASPECT of DIP switch 3 on the rear
panel is set to 4:3.
• When the image size selector on the front panel is set
to a position other than SML and NOR and the
STD/SIDE selector is set SIDE, and ASPECT of DIP
switch 3 is set to 1:1.
Under any other conditions except those above, the print
line density is not set to high even if you set the switch
to ON.
III
255
Setting the DIP Switches on the
Rear Panel
To change the DIP switch settings
Use a small pointed tool such as a small screwdriver.
The factory settings are as follows.
1 2 3 4 5 6 7 8 9 q; qa qs
DIP SW
UP
1 2 3 4 5
DOWN
DIP SW
REMOTE
UP
DOWN
DIP SW FUNCTION TABLE
NO. FUNCTION SW-DOWN
1 INTERRUPT ON
2 POSTFEED ON
3 ASPECT 4:3
4 MEMORY FRAME
5 DIRECTION NORM
6 SCAN –
7 WIDE 1
8 OUTPUT THRU
9 AGC OFF
10 RESERVED –
11 INPUT B & W
75 Ω
12 ON
SW-DOWN or SW-UP indicated in parentheses
shows the switch position.
Setting Up the Printer
6 7 8 9 10 11 12
t IN T OUT
VIDEO
AC IN
UP-895MD/895CE
SW-UP
OFF
OFF
1:1
FIELD
REV
WIDE 2
NORM
EE
ON
–
COLOR
OFF
Preparation
23