Sony UP-2300P Mode D'emploi page 106

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Error/Warning Messages (continued)
106
Others
7
Load the paper into the paper tray correctly.
Do not reuse the paper put back in step 5. Discard that paper.
Set the paper securely
under the tab
8
Remove the ink ribbon cartridge.
If there is a jammed paper, slowly pull out the paper.
If the ink ribbon cartridge cannot be removed, the printer must not be
operated. Contact your Sony service facility.
When you cannot see the jammed paper, go to step 9.
9
Open the top white cover, then the black cover.
If the paper has jammed inside, slowly pull the paper out.
If the jammed paper cannot be removed, the printer must not be operated.
Contact your Sony service facility.
10
Re-insert the removed paper tray, paper cover or ink ribbon cartridge if you
removed, then close the front panel.
11
Turn on the power of the printer.
When the message does not appear, you can use the printer as normal.
However, the image captured to memory have been cleared. Capture the image
to memory again.
If the same message appears again, the printer must not be operated. Turn off
the power immediately and contact your Sony service facility.
Note
Do not open the top cover during printing because of mechanical hazard. If you do,
turn off the power switch of the printer.
Open this cover, too

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Up-2330pUp-2800pUp-2850pUp-2900mdUp-2950md

Table des Matières